7
ENGLISH
UNIVERSAL ATTACHMENT (6)
The universal attachment (6) allows to adjust the remain-
ing hair length from 0.5 mm to 10 mm with a step 0.5 mm.
•
When you use the universal attachment (6) for the
first time, it is recommended to set the maximal
remaining hair length "10" to learn about this trimmer
system. During further use of the universal attach-
ment (6) you can set the required remaining hair
length from 0.5 to 10 mm with a step 0.5 mm.
•
Insert the blade block into the universal attach-
ment (6), press on the upper part of the attach-
ment (6) until the lock clicking (pic. 5). Set the
remaining hair length by turning the control knob
counter/clockwise.
•
When cutting hair make sure that the flat part of the
universal attachment (6) is in full contact with the skin
for even hair cutting (pic. 6).
Note: - as hair grows in different directions, you can
try various movements of the attachment (6) upwards,
downwards, to the left or to the right.
CLEANING AND MAINTENANCE
– Switch the trimmer off after use.
– Remove the installed attachment (6), to do this lift
the rear part of the attachment and remove it (pic. 7).
– Clean the attachment (6) off hair with the brush (8).
– Clean the blade block (1) with the brush (8), you can
wash the blade block (1) under a water jet (pic. 8).
– Clean the trimmer body with a soft, slightly damp
cloth, and then wipe it dry.
– Never immerse the trimmer, the power adapter (9)
and the power cord into water or any other liquids.
– Never use solvents or abrasives to clean the trimmer
and the attachment (6).
– Lubricate the blade block (1) after every use with the
lubricating oil (7).
– If you need to remove the blade block (1), move the
pusher button (2) upwards and remove the blade
block (1) (pic. 9). To install the blade block (9) insert
the guides on the blade block (1) into the openings
and press on the blade block (1) until the lock click-
ing (pic. 10).
VT-2560_70 x130.indd 7
21.05.2018 12:14:41