6
ENGLISH
WARNING:
– Do not charge the battery at temperature below +5°C
and above +35°C.
– If you haven't used the unit for a month or longer, charge
the battery completely before using the trimmer.
– Do not leave the unit connected to the mains unat-
tended.
LUBRICATING THE BLADE BLOCK
Before using the unit for the first time lubricate the blade
block (1) with oil (7) (supplied with the unit).
– Apply the lubricating oil (7) to the junctions between
the fixed and moving parts of the blades.
– Switch the trimmer on by pressing on the switch (3)
"
" and let it operate for approximately 30 seconds
to spread the oil across the rubbing surfaces. Switch
the trimmer off by pressing on the switch (3) "
" and
remove the excess oil with a dry cloth or a paper towel.
Note:
– Lubricate the blade block (1) after every use of the
trimmer.
– For lubricating the blades use only the oil (7) supplied
with the unit, or the oil intended for similar devices.
– Do not use vegetable oil or oil with solvents. Solvents
will evaporate, and the remaining thick oil may slow
down the blades motion.
USING THE TRIMMER
•
The best shaving results are achieved if your skin is dry.
•
Switch the trimmer on by pressing on the power
switch (3) "
".
•
Make sure that the blade block (1) is perpendicular
relative to your skin (pic. 1), move the blade block (1)
making reciprocative motions (pic. 2). Use both edges
of the blade for making sharp lines and perfect edges.
•
To accentuate the sideburns or the area around the
mouth or nose hold the trimmer with one of the blade
edges touching the skin. You can make sharp edges
or lines like this (pic. 3, 4).
•
After shaving switch the shaver off by pressing on the
power switch (3) "
".
•
Clean the shaving block (1) with the cleaning brush
(8) after every use.
VT-2560_70 x130.indd 6
21.05.2018 12:14:41