Vitek VT-2354 BK, Manual Instruction

Page: 4 / 28

4
ENGLISH
a person who is responsible for their safety or
if they are not instructed by this person on the
usage of the unit.
• Do not leave children unattended to prevent
using the unit as a toy.
•
For children safety reasons do not leave poly-
ethylene bags, used as packaging, unat-
tended.
Attention! Do not allow children to play with
polyethylene bags or packaging film. Danger of
suffocation!
• Never pull the power cord when disconnecting
the unit from the mains; take the power plug
and carefully pull it out of the mains socket.
•
Never use the unit if the power cord or the
power plug is damaged, if the unit works
improperly or after it was dropped.
•
Do not attempt to repair the unit. Do not disas-
semble the unit by yourself, if any malfunction
is detected or after it was dropped, unplug
the unit and apply to any authorized service
center from the contact address list given in
the warranty certificate and on the website
www.vitek.ru.
• Transport the unit in the original package only.
• Keep the unit out of reach of children and dis-
abled persons.
THE UNIT IS INTENDED FOR HOUSEHOLD
USAGE ONLY
BEFORE THE FIRST USE
After unit transportation or storage under
cold (winter) conditions, it is necessary to
keep it for at least three hours at room tem-
perature.
There may be water spots in the air humidi-
fier, this is normal, as the unit has undergone
factory quality control.
–
Unpack the unit, remove any stickers and
package materials that can prevent unit oper-
ation. Check the unit for damages. In case of
damages do not switch the unit on.
–
Before plugging the unit in make sure that
your home mains voltage corresponds to the
unit operating voltage.
Notes:
Use the air humidifier at the room temperature
from +10° С to +40°С, and relative humidity less
than 80%.
Water temperature should not 40°С.
Installing batteries in the remote control
(RC)
• Open the RC battery compartment lid and
insert a CR2025 battery, strictly following the
polarity.
•
Install the battery compartment lid back to
its place.
Note: The unit can be supplied with the battery
installed in the RC battery compartment. In this
case if there is an isolation insert in the RC bat-
tery compartment, remove the insert.
Battery replacement
•
Open the battery compartment lid, replace
the old battery with a new one, strictly follow-
ing the polarity, then close the battery com-
partment lid.
USING THE AIR HUMIDIFIER
–
Remove the nozzle (1).
–
Take the water tank (4) by the handle (3) and
remove it from the unit body (7).
–
Turn over the tank (4), unscrew the lid with
the cartridge filter (5) rotating it in the direc-
tion of the arrow
and remove it. Fill the tank
(4) with the necessary amount of water, insert
the lid with the cartridge filter and screw the lid
(5) rotating it in the direction of the arrow
.
–
First place the filled water tank (4) back
to its place and then install the nozzle (1).
Wait till the process chamber (6) is filled
with water.
–
If you want to use the aromatization function,
remove the water tank (4) and remove the aro-
matic oil container (10). Add some drops of
water-soluble aromatic oil on the sponge and
install the container (10) and the water tank
(4) back to their places.
Notes:
•
Use water-soluble aromatic oils only.
•
If you are not going to use the aromatiza-
tion function, remove the sponge from the
container (10), wash it and install back to its
place.
–
Insert the power plug into the mains socket.
–
Switch the unit on by touching the button
(12). You will hear a sound signal, the rela-
tive humidity indications «%» will light up on
the display (8), and the air humidifier will start
operating that is indicated by intense ≪mist≪
release from the nozzle (11).
IM VT-2354.indd 4 29.04.2016 17:04:00