9
ENGLISH
Step 5 – the final part
– In the final stage of hair cutting remove the attach-
ment comb from the unit, turn the blades (1) of the
clipper towards the hair and trim hair on the temples
and neck carefully. Do not press the clipper strong-
ly, there is danger of injuries or cuts when open
blades (1) come in contact with skin (pic. 9).
Cone-shaped haircut
Set the necessary attachment comb and start cutting
from the head back towards the crown. Cut the hair
against the direction of the growth, towards the crown,
and from the sides (pic. 10). To get a flat top haircut, use
the comb: lift the locks and cut them along the comb.
Comb the hair to reveal uneven locks.
After cutting your hair, switch the hair clipper off by
setting the switch (4) to the position “O” and unplug it.
CLEANING AND MAINTENANCE
Lubricating the blades
Lubricate the blades (1) before and after every use of the
hair clipper with the oil (11) supplied with the unit.
– Switch the unit off using the power switch (4) and
unplug it.
– Apply one-two drops of oil (11) on the blades (1) teeth
and on the back side of upper blade, switch the hair
clipper on and make sure that the blades are mov-
ing smoothly.
– Switch the unit off, clean the excess oil with a dry cloth.
Attention! Use only the oil (11) supplied with the set.
DO NOT USE vegetable oil, fat, oil mixed with any sol-
vents for lubricating. Solvents will evaporate, leaving
thick grease that may slow down the blades’ motion.
Cleaning the hair clipper
– Switch the hair clipper off and unplug it.
– Clean the blades (1) from the cut hair using the clean-
ing brush (12).
– Wipe the accessories and the hair clipper body (3)
with a slightly wet cloth, and then dry them with a
soft cloth.
– Do not immerse the hair clipper into water or other
liquids.
