Vitek VT-1312, Manual Instruction

Page: 6 / 40

6
ENGLISH
Nozzle
Use the nozzle (2) when you need to focus the power
of drying on a small area (for example, a curl or a wave)
or when you want to straighten wavy hair.
–
Attach the nozzle (2) to the hairdryer body. The noz-
zle (2) allows directing a narrow air flow of high inten-
sity at a definite hair lock.
– Insert the power plug into the mains socket. Use the
switch (1) to set the necessary operation mode.
–
After unit operation, switch the hairdryer off by setting
the switch (1) to the position «
0 », and unplug it.
Overheating protection
Overheating protection switches the hairdryer off if the
outgoing air flow is too hot. If the hairdryer switches
off during operation, set the operation mode switch (1)
to the «
0 » position, unplug the hair dryer and make
sure that the inlets and outlets are unblocked. Let the hair-
dryer cool down for 5-10 minutes and switch it on again.
Do not block the air inlets during the hairdryer operation
and keep your hair from getting into the air inlet grid (3)
CLEANING AND CARE
– The hair dryer is intended for household use only.
– Set the switch (1) to the position « 0 » and disconnect
the hair dryer from the mains.
– You may wipe the unit body with a damp cloth and
then wipe it dry.
– Clean the air inlet grid (3) with a brush.
– Never immerse the unit into water or other liquids.
– Do not use abrasives and solvents to clean the unit
body.
STORAGE
– Unplug the hair dryer if you are not using it.
– Let the hair dryer cool down after its usage, keep the
unit away from children in a dry cool place.
– Never wind the power cord around the hairdryer, as
this can damage the cord. Handle the power cord with
care, do not pull, twist or stretch it, especially near