Vitek STARLIGHT VTC-IRM30-2812, Manual

Page: 10 / 32

Operating Instructions
Setup menu can be accessed and controlled by OSD control joystick on
the side of the camera. Five commands are available with the joy stick.
The design of OSD could be different according to the Model.
Using OSD Controller
Cover Open
Video Sub-out
Connector
OSD Control Joy Stick
SUB-OUT
ZOOM
1] SET Key (●) : Access to the menu or enter the setting.
To enter the main menu, press the Set Key down.
2] UP/DOWN Key (▲/▼) : Choose the desired sub-menu and to move
the cursor up or down.
3] LEFT/RIGHT Key (◄/►) : Set up the value of the selected menu. Used
to adjust the desired menu selection and to move the cursor left or right.
Description of the OSD control operation
Description of the Motorized ZOOM&FOCUS* adjustment
1) ▲ : Zoom In
2) ▼ : Zoom Out
3) ◄ : Focus Near
4) ► : Focus Far
(*) Works only when OSD Menu is inactive.
ANALOG OUT should be set to TVI MODE, AHD MODE or CVI MODE
to get CVBS video in sub-out. If it is set to CVBS, there is no CVBS video
in sub-out port. (SYSTEM> OUTPUT> ANALOG OUTPUT0)
If CVBS video is enabled through ANALOG OUT or Sub-out port, WDR
and 3D-NR functions are disabled in all video outputs.
It should be considered when installer adjusts the video with installation
monitor via CVBS video signal.
10 11