9
Installation Instructions (continued):
3. Loosen stem-nut on the faucet.
4. Slide Chrome Plate and Black Rubber Washer onto the faucet stem. The chrome plate,
rubber washer and faucet body are installed above sink or countertop.
5. Feed the
3/8
” and
¼
” black tubing through the pre-drilled hole in the sink/counter.
6. Place the faucet through the drilled faucet hole, then add Spacer, Securing Plate, Star
Lock Washer and Stem Nut.
7. Tighten stem nut firmly while aligning faucet in the desired location.
8. Gently slide Faucet Compression Nut down over the
¼
” blue tubing, follow with Ferrule.
Then push Insert into the end of the tubing.
9. Firmly push the tubing into the stem of Faucet until it stops. Hand-screw the nut onto the
threads of the stem. Tighten with a wrench.
1. Attach the drain clamp to the vertical section of the drain pipe, about 2 inches above the
drain trap.
2. Using the fittings hole of the drain clamp as a guide, drill a ¼” hole through one side of
the drainpipe.
CAUTION: Do not penetrate through the opposite side of the pipe.
3. Remove the drain clamp from the drainpipe and enlarge the hole with a
3/8
” drill bit. Use
a file to remove rough edges from the drilled hole.
4. Cut the end of the
3/8”
black tube at a 45˚ angle and insert it through the saddle drain
clamp quick connect fitting about 1” past the inside wall of the saddle clamp.
Counter top
Counter top
Spacer
Stem Nut
Lock Washer
Securing Plate
Insert
Ferrule
Faucet
Compression Nut
Chrome Plate
Rubber Washer
1/4” Blue Tubing
Push into stem
3/4” deep
until it stops
Figure 7.
Figure 8.
Installing the Air Gap Faucet Continued (see figure 7 and 8):
Installing the Saddle Drain Clamp (see figure 9 and 10 on the next page):
