3
CHARGING YOUR SHAVER
Blade Alignment
•
Your clippers were carefully examined
to ensure that the blades were oiled
and aligned before leaving our factory.
•
Blades must be realigned if they have
been removed for cleaning or replacement.
•
To realign the blades, simply match the upper and bottom blades teeth up - point
for point. (End of top blade teeth should be approximately 1.2mm back from
bottom blade.)
•
If blade alignment is incorrect, add a few drops of oil to the blades, turn clipper
on for a few moments, turn off and unplug. Loosen screws slightly and adjust then
tighten screws after blade is aligned
Oil
•
To maintain your clipper in peak condition, the blades should
be oiled every few haircuts.
•
Do not use hair oil,grease, oil mixed with kerosene or any
solvent, the solvent will evaporate and leave the thick oil which may slow the
blades motion.
Power Screw
•
The power screw permits you to adjust the power.
It has been adjusted before leaving the factory. However, if the voltage in your
home is low, you may need to readjust it.
•
To adjust, use a screw driver or a thin coin to turn power screw in clock
wise direction until the arm strikes the coil; making a noise. Then slowly turn
power screw out (counter-clockwise) just until noise stops. This is maximum
power setting.
Blade Lever
•
The lever is conveniently located near your thumb (if you’re right-handed) so it
can easily be adjusted while the clipper is in your hand.
•
The lever adds versatility to your clipper by allowing you to gradually change the
closeness of your cut without an attachment comb.
•
When the lever is in the upper it is in the highest position,the blades will give
