VITAECO HotmixHOME, Instruction Manual, Page: 8 / 30

8
HEATING ELEMENT (15)
Electrical device for heating the bowl while cooking.
WARNING: do not heat the bowl when empty!
WARNING: do not touch it, it could cause burns.
PROBE (14)
It is the element enabled to control the temperature set.
LIQUID LEAKING HOLE (16)
Whenever some liquids should come out of the bowl, they will go out from the appliance base, throughout
this hole.
WARNING: check that the hole is not blocked periodically!
WARNING: the even partial blockage of this hole could cause serious damage in case of liquid leakage
out of the bowl.
STABILIZING FEET (12)
The four elastic feet at the base of the appliance work as shock absorbers and stabilizing elements of any
oscillation when the appliance is operating.
WARNING: it may happen that, depending on the food preparation, the appliance could make visible
oscillations: this is absolutely normal, and the stabilizers will absorb any oscillation.
LIQUID CRYSTAL DISPLAY (7)
Once the appliance has been switched on, the Hm HOME logo will appear on the display.
If the lid of the bowl is open, the icon of the lid will switch on and the indication “LID OPEN” will appear.
After closing the lid safely, the icon and the written indication will disappear and the display will show: the
speed icon with the last programmed value and the indication “SET SPEED”: at this point, the appliance is
ready to be programmed. When temperature is being set, the thermometer icon will switch on, together
with the indication “SET TEMPERATURE”.
When pressing the “CLOCK” switch to set time, the clock icon will switch on with “00:00” digits, and the
“SET TIME” indication will appear. The display will show the remaining time slipping by.
After 5 minutes of inactivity, the display goes into standby in compliance with the regulations.
In case of severe fault, the spanner will switch on while anything else will switch off. The appliance must
then be brought to a service center.
MOTOR CONTROL THERMOSTATS
Your appliance is equipped with two thermostats for motor protection: one dynamic and one static. The
dynamic thermostat always intervenes before the static, which stops the machine pointing Er: 01.
The dynamic thermostat, in fact, make an “
intelligent ” control of the motor temperature, stopping for a
moment, if necessary, to cool the motor down and finish the recipe, before involving the static thermostat.