STEP 1
STEP 2
Attach the four wall mount standoff brackets (B) to the two upright beams (A) as shown by removing the pre-installed
5/16" bolts and washers (discard cardboard retainer) then place the standoff bracket over the threaded spring nuts and
re-install the washers and bolts. DO NOT TIGHTEN BOLTS YET.
Measure 12" from the TOP end of the upright beam to the standoff bracket as shown below then securely tighten bolts.
Measure 17" from the BOTTOM end of the upright beam to the standoff as shown below then securely tighten bolts.
Attach the top rung (C)
Lay the two upright beams on the floor 32" apart. (center to center) Loosen the bolts on the top rung saddles
just enough to insert the first wood rung. Position this wood rung under the top saddles locating the saddle
between the two saddle postion marks at each end of the rung. DO NOT TIGHTEN YET.
Measure 7-3/4" from the TOP of the upright beam to the TOP of the wood rung as shown below.
Securely tighten all four saddle bolts.
STEP 3
T
O
P
12"
Reserved for
chin up bar
5/16" x 1" Bolt
Split Lock Washer
Flat Washer
Standoff Bracket
Upright Beam
T
O
P
17"
CSB3670C3
T
O
P
7-3/4"
7-3/4"
Reserved for
chin up bar
Saddle Marks
Standoff Bracket
Saddle
Spacer Block
Place the spacer block at both sides
when tightening saddle bolts.
(One spacer block provided)
Spacer Block
Attach the balance of rungs (C)
Once the top rung is in the correct position and securely tightened, begin attaching the rest of the rungs
working from the top to the bottom. Again, loosen the bolts at each saddle just enough to insert the wood
rungs. Position the wood rung under the saddles and locate the saddle between the saddle postion marks
at each end of each rung. DO NOT TIGHTEN YET. Use the supplied wood spacer block (I) to evenly space
the balance of the rungs by placing this spacer between the rungs as shown above. Once you have the rungs
spaced out you can then securely tighten the saddle bolts. Note: These instructions are for evenly spaced
rungs (8-1/2" center spacing) you can space the rungs to your desired location if you prefer.
Bottom Foot
32"
Saddle Marks
