1. Follow steps one through three of ‘Using The Pre-Set Programmed
buttons’ section on page 14.
2. The speed of the motor can be changed with:
3. The PULSE buttons can also be used to temporarily increase the motor
speed or decrease the motor speed. (See HIGH/LOW PULSE button
description on page 5.)
4. When done blending press the START/STOP button to stop the motor.
Wait until blade comes to a complete stop before removing the lid
and/or container from the motor base.
5. Remove the container from the motor base and serve the drink.
NOTE: On all units the built-in thermal sensor keeps track of how hot the
motor gets and will warn the user and eventually shut down the motor if the
motor is overheating. When overheated the display will instruct the user to
remove the container and run the machine until cool. This takes about a
minute. See page 23 “Cooling the motor” for complete instructions.
When overheating occurs, review your techniques and instructions. The
motor may be getting hot when your recipes are too thick. Consider adding
more liquid or consult Vita-Mix for further assistance.
Retainer Nut Removal
• The retainer nut is easily removed using a
15 cm screwdriver.* Turn container upside
down and insert screwdriver shaft between
the lobe and drive spline. Push the screwdriver
handle counterclockwise to loosen nut. Once
loosened, remove by hand.
• To replace, position retainer nut on top of
blade assembly and hand tighten. Then, using
the screwdriver, tighten clockwise until it
stops. If it is not tight enough, you will notice
increased container noise.
*For best results we
recommend using a
Retainer Nut Wrench
in place of a screwdriver.
To order ask for item #1222
Blade Agitator Assembly. Use caution when
handling the blade; it is sharp. When inserting the
blade assembly through the container bottom, grip
the blades with a soft cloth, align the flat sides of the
blade assembly with the flat sides of the container.
Place the retainer nut back on the inserted blade
assembly and tighten clockwise. Do not force. Do
not attempt to disassemble blade assembly.
Drive Spline. Mates with drive socket on the motor
base to turn the blade. NOTE: Removing and
replacing your container while the coupling is still
rotating will strip the drive spline “teeth”. (This part
is NOT removable.)
Retainer Nut. Must be snug. Use the available
retainer nut wrench for best results. (Refer to the
diagram below to remove or replace.)
Never use a blade assembly with loose, damaged or knicked components.
Retainer Nut
Lobe
Drive Spline
B
lade Agitator Assembly
I
nstructions
16
17
CONTINUED FROM PAGE 15
• the motor off.
– Press the
▲
or
▼
buttons
until the desired speed
percentage is displayed.
100% is the highest setting
and 7% is the lowest setting.
– With the container in place,
press the START/STOP button.
The motor will ramp quickly to
the selected speed.
– Blending can be stopped by
pressing the START/STOP
button at any time.
• the motor on.
– With the container in place press,
the START/STOP button. The
machine will begin blending.
– While the machine is running
Press the
▲
or
▼
buttons
until the desired speed
percentage is displayed.
100% is the highest setting
and 7% is the lowest setting.
– Release the SPEED CONTROL
button and the motor will now run
at the desired speed.
– The blending can be stopped by
pressing the START/STOP button.
Container (bottom view)