VI-‐1100 & VI-‐100-‐P
Installation Guide
01A.02
15
A.
Use “Obtain an IP address via DHCP” if users want network to provide automatic
address.
B.
Use “Use the following IP address” and type specific addresses if users want the
device to use specific designated address.
7.
Click Apply button and wait for system to correspond.
8.
Disconnect the wired cable from the camera and wait for 10~15 seconds.
9.
Identify the wireless device from the refreshed IPAdminTool or Windows Explorer by
accessing the network folder.
IPAdminTool needs to be opened in a same network where wireless device is
operating.
6.4. Reset
1.
While the device is on, press the reset button for 1~2 seconds.
2.
Wait for the system to reboot.
6.5. Factory Default
1.
While the device is on, press reset button and hold.
2.
Release the Reset button after about 5 seconds when green LED blinks, which is located in
the front panel, at rate of 200ms.
3.
Wait for the system to reboot.
The factory default settings can be inferred as follows:
Caution
!
IP address:
192.168.xx.yy
Network mask:
255.255.0.0
Gateway:
192.168.0.1
User ID:
root
Password:
pass
