VISTEK V1636, User Manual, Page: 10 / 12

Vistek V1636 24-bit Audio Digital
To Analog Converter
10 HU-V1636
·
Holding the or p or q buttons down will cause the value of the parameter to auto
increment and autodecrement respectively. The longer the button is held down,
the faster the rate of autoincrement or autodecrement.
·
Once a parameter has been adjusted to the desired value, the Panel Adjustment
mode is exited by pressing the SELECT button until all four of the LEDs above
the SELECT button are off. NOTE: Only when Panel Adjustment mode is
exited will the parameter adjustments take effect.
·
The V1636 has non volatile memory storage that automatically saves the values
of all the operating parameters so that on power-up, the last used settings will be
invoked.
The following table indicates the available Panel Adjustment modes on the two pages.
LED
indicator
Page 0 Page 1
Parameter Adjust range Parameter Adjust range
Delay Delay 0ms to 1250s Test Tone A,B Off/A,B on
- - -
- - -
A/B Swap A/B Swap Normal/Swapped -
3.2.2 Delay Adjustment
·
A fixed delay may be applied to all four analog channels as a group and the
present setting may be seen on the character display as a number when Page 0
Panel Adjustment mode has been entered and Delay selected as a parameter.
·
By Panel Selection the delay value may be adjusted from 0ms to 1.25 seconds.
Adjustment from 0 to 99ms is in 1ms steps, and adjustment from 100ms upwards
is in 10ms steps. From 0 to 999ms, the delay value is displayed in ms and from
1.0s upwards it is displayed in seronds.
·
The DART interface can control the delay in 1ms steps across the range.
·
The minimum throughput delay of the V1636 is less than 1ms.
Note: changing the fixed delay will cause a temporary disruption of audio for not less
than the value of the new delay setting.