www.vistacnc.com
- 5 -
www.vistacnc.com
- 5 -
iMach
III
P1A-S Pendant Manual v4.0.0
□
Program Run screen page. Other screen page: MDI, ToolPath, Offsets, Settings and Diagnost.
1.4 Axis zeroing
When Axis Selection knob is at X, Y, Z or A position, turn MPG few steps to zero selected axis.
->
2. MPG (Manual Pulse Generator) mode
2.1 STEP / VELOCITY mode
2.1.1 In STEP / VELOCITY mode, turning MPG wheel at higher speed automatically changes
MPG mode from STEP mode to VELOCITY mode.
To set to STEP only mode, select 0 in STEP to VELOCITY mode change sensitivity in Plugin
Configuration Table
.
Use MPG cap to turn the MPG wheel to get lower speed for STEP mode. Use MPG handle to
turn the MPG wheel to get higher speed for VELOCITY mode
.
STEP to VELOCITY mode change sensitivity can be set up in Plugin Configuration Table
.
2.1.2 In STEP mode, the selected axis moves 1 step at each MPG click (detent) with the step
size and feed rate currently in the system.
A fixed feed rate which is only used in Step mode can be setup in PlugIn Configuration table.
