Vista VVRD28V12CM960H / U, Installation Manual

Page: 17 / 24

16
B/W: Monochrome only operation
Burst: Off, On
(Allows the colour burst signal in monochrome to be removed if required)
IR Optimizer: Off, On (if On, then Mode & Level are adjustable)
Mode: Auto, Centre
Level: 0
– 31 (increments of 1)
Ext 1: Switches to permanent mono mode and reflects the setting in B/W mode
Ext2 (auto switching between colour& monochrome on DNLED models)
Camera switching operation is determined by the photocells
– there is no
programmable delay time or switching level.
NR (2DNR)
Digital noise reduction is used to remove ‘noise’ from the image in low light
conditions when AGC is applied.
NR mode : Off, Y, C, Y/C (Sets the 2D NR filter mode)
Y Level: 0
– 15 (increments of 1) Sets the Y filter (Luminance) strength.
C Level: 0
– 15 (increments of 1) Sets the C filter (Chrominance) strength.
CAMERA ID
Sets the camera ID to ON or OFF. A title of 26 characters per line can be
applied.
CHR1
Allows you to edit line 1
CHR2
Allows you to edit line 2
CLR
Inserts a space
POS
Allows you adjust the location of the camera ID title display.
Use the joystick to navigate
the cursor. Pushing centrally
on the joystick will allow
selection of that character.
The arrows at the bottom
allow you to move the cursor
without changing the
character.