VIPER quick ser guide V1.0
5
Auto Detection
This is the simplest method of registering cameras; it can be used with any of the Vista VK2 range of cameras
or third party manufacturer’s cameras that support “Zero Config”
The cameras must be connected directly to the PoE ports of the NVRs built in switch, and the cameras ID and
Password must both be set to “admin”, and the network settings, set to DHCP( This is the default setting for the
VK2 range.)
Connect the cameras to the PoE ports of the NVR, the physical port numbers relate to the screen segments on
the 16 way split screen display: 1 = top left, 16 = bottom right.
Power up the NVR, it will take a minute or so to boot up, then will automatically detect the connected cameras
and apply IP address using DHCP.
Wait for a short while, icons showing a camera and rotating blue dots will be displayed in screen segments
relating to port positions on which cameras have been detected.
After a couple of minutes the images from the cameras will be displayed.
Once all the cameras are displayed, the stream and image settings can be configured using the IP Camera
Setup” and “Image Setup” sections with in the NVRs main menu. For more details see the following sections in
this manual.