9
2. First remove the camera module by pulling down on the taps that hold the
camera module in place
[fig A]
3. Knock out the screw access holes (T1), this is can be done by using a
Cross head screwdriver
4. Pull the video / power cables through the cable hole, then connect in the
normal way
5. Attach the dome base to ceiling or wall using mounting screws, plastic
anchors (If required, remove the side knock-outs for cable entry, make sure
the video & power cables are properly arranged in the cable notch>
6. Insert the camera module, remove the liner
7. Adjust the camera module to the area you want to view, then adjust the
zoom and focus to suit
8. Carefully fit the liner over the camera module so that it snaps into place
[fig B]
9. Close the dome cover by rotating clockwise
10. Secure the dome cover using the tapping screw
NOTES:
If the 2.1mm jack adaptor is not used then please ensure the
correct polarity is observed when 12VDC is being used. The
terminals are colour coded to assist: Red = 12VDC / Black = 0V
If using the UTP (U) models, note that you cannot use the BNC
output at the same time
[fig A]
[fig B]
