Vista smartdisc 10IPRT VLS2-10IPRT, Quick Installation Manual

Page: 17 / 22

Vista Quick Installation Guide
SmartDisc 10IP
RT
11
1.8.3 TCP/IP Crossover Connection from SmartControl to the Device
Preparing the receiver PC
Your Vista SmartDisc 10IP
RT
can be accessed when in its default status or following a device reset using the
following IP address: 192.168.31.95
Note: The precondition for communication via a TCP/IP crossover network cable between the SmartDisc
10IP
RT
and the receiver PC with SmartControl is that the devices are located in the same IP
address group (here: 192.168.31.x).
Check and if necessary change the TCP/IP settings for the network interface (Start\System Control\Network
Connections\LAN Connection\Properties\Internet Protocol (TCP/IP)), via which your device is connected via
the TCP/IP crosslink cable.
l
Note down the current settings for the IP-address and Subnet mask.
l
Change these settings:
l
IP address (e.g.): 192.168.31.66
l
Subnet mask: 255.255.255.0
Establishing the connection to the device
Start SmartControl. Click on the Dial button. In the Transmitter index dialogue window, click on the Add
button and then select from the next selection menu Add new transmitter.
In the dialogue window, enter a transmitter name and the IP address for the device. IP Address:
192.168.31.95
Confirm the dialogue window with OK.
Select the new entry using the transmitter name. Establish a connection to the device using Dial.
To change the settings for the device (See "Parameter settings for the device" on page 12).
Follow-up preparation of the receiver PC
Once the settings for the device have been made, you may need to change the receiver PC IP address and
Subnet mask to allow connection.