11 HOMEDEPOT.COM
Please contact 1-855-847-7264 for further assistance.
Operating Instructions (continued)
LED LIGHT
Press the
button to turn the LED light on and off.
To enhance the lifespan of the LED light and conserve energy, it is recommended to predominantly utilize the light
for loading and selecting beverages.
SHUTDOWN
If the beverage cooler will not be in use for a long period of time, disconnect it from the power outlet, clean inside
thoroughly, and leave the door open to prevent mildew.
DEFROSTING
Frost may develop on the interior back panel of the unit when the temperature setting is very low and the unit is
not fully stocked with beverages. The presence of frost may force the unit to run continuously and thus increase
internal temperature.
To defrost the beverage cooler:
1. Use the
▲
and
▼
buttons to increase the temperature until the compressor turns off.
2. Allow the internal ice/frost buildup to melt. Ensure the internal drain (located at the middle back of the lower
shelf) is not clogged.
3. During this time, the melted frost flows through an internal drain into a holding pan on top of the compressor.
The heat of the compressor evaporates the liquid.
4. Reset the temperature to 43 °F (6 °C) and allow to cool for at least one hour.
5. Adjust the unit to the desired temperature setting.
Care and Cleaning
PROTECT FROM MOISTURE
Heavy moisture in the environment can cause
degradation to the insulation, as well as rust to the
cabinet, compressor, and/or power supply.
It is important to periodically clean and maintain the
beverage cooler. When performing maintenance, make
certain the unit is unplugged from the power outlet.
Wipe the inner and outer surfaces of the beverage
cooler clean with a damp cloth. If needed, use a gentle
detergent or a solution of baking soda and water.
Remove any residue with clean water and a soft cloth,
then dry with another cloth.
Once clean, you may use a common kitchen appliance
wax on outer surfaces.
Inspect, clean, and maintain the rubber gasket around
the door. A small amount of petroleum jelly applied to
the bracket side of gaskets will keep the gasket pliable
and ensure a good seal.
IMPORTANT:
□
Do not use hot water, harsh detergents,
gasoline, kerosene, solvents, acids, or anything
flammable to clean the beverage cooler. These
can damage the paint and degrade the plastic
components.
□
Do not spray the beverage cooler with water
as this may cause rust and degrade the
insulation.
□
Do not clean glass shelves with hot water
when they are cold. Shelves may break if
exposed to sudden temperature changes or
impact. For your protection, tempered glass is
designed to shatter into many small pebble-
size pieces.
□
For replacement components, they must be
obtained from Vissani Customer Service. This
ensures the correct replacement components
are provided, and minimizes risk of possible
ignition due to incorrect parts or improper
service.
