3
Kado 25
b
a
For calculating glass panel A x B:
A
=
length L –
52 mm
/2.047"
B
=
length L –
57 mm
/2.244"
L
A
L
B
For calculating glass/wooden
shelf A x B:
A = length L –
52 mm
/2.047"
B = length L –
52 mm
/2.047"
L
A/B
R 7
0.276"
16
0.630"
14
0.
55
1"
1/2019 (US)
Connecting technique
1. Section turned 45°
2. push over connector to buffer
3. turn 45° with tool 923-025.21
4. and level.
Assembly Kado
1. Assemble horizontal frame on a flat surface.
- Corner connectors with holes for glides or castors at bottom
- holes in the shorter connectors face upwards in the lower frame and
face downwards in the upper frame.
2. Upright connecting sections (some with pitched slots) to be slotted at
45° between the frames (up to the buffers) and then turned 45° using
the assembly tool. The slots face inwards for accessories.
Gondolas with castors only recommended up to a max. height of
1320 mm
/51.969". Max. height of gondolas
1830 mm
/72.047".
Please observe the indications concerning weight loads and ensure that the substructure of the wall units/furniture and their fixtures can
support the expected loads.
With free-standing furniture, ensure that there is sufficient stability even with the intended merchandise supports.
Assembly dimensions / Layout
All structures of Kado 25 function according to the same principle and can be supplied either unassembled, partly assembled or fully assembled.
Assembly instructions
1. Fit all glass panel retainers (
a
).
2. Put the glass between the clips.
3. Insert locking peg (
b
) in retaining clip.
Glass side panels with glass panel retainers
Glass and wooden shelf top and plinth
Glass shelf:
insert shelf carrier into horizontal tubes and lay glass plinth on shelf carrier.
Wooden shelf:
insert shelf carrier into horizontal tubes without rubber shelf rest and lay
countersunk wooden plinth on shelf carrier.
glass
wood
