COVER CLOSURE
1.
Release locking
2.
Adjust
3.
Lock
4.
Release locking
5.
Adjust
6.
Lock
7.
Turn cover and push slider
8 & 9.
Put back cover
10.
Secure with screw
A.
Vertical angle steps
Figure 3 - Adjustment and Cover Closure
2.2. Battery Insertion
It is recommended to perform the first batteries insertion on a flat surface (see Figure 4). After battery insertion, the LED will flash for 60 seconds and
then the detector will enter a 15 minutes' local diagnostic mode.
A.
Tamper switch
B.
Press firmly to release the bracket
C.
3 screws
Figure 4 – Battery Insertion
2.3. Enrollment
Refer to the PowerMaster control panel's Installer Guide and follow the procedure under the
"02:ZONES/DEVICES"
option of the Installer Menu.
A general description of the procedure is provided in the following flow chart.
Step 1
Step 2
Step 3
Step 4
Enter the Installer menu and select
“02:ZONES/DEVICES”
Select "ADD NEW DEVICE"
See Note 1
Enroll the device (see Figure 5) or
enter the device ID
Select a detector number for the
new flood detector
02:ZONES/DEVICES
ð
ADD NEW DEVICES
6
ð
ENROLL NOW
or
ENTR ID:XXX-XXXX
ð
Z14:Motion Sens
ID No. 130-XXXX
ð
MODIFY DEVICES
Step 5
Step 6
Step 7
Configure Location, Zone Type &
Chime parameters
Enter PARTITIONS.
See Note 2
Assign partitions to the detector by
pressing the
,
and/or
buttons on the
D-304046 TOWER-20 PG2 Installation Instructions
3