2
D-305640 SR-720B PG2 Installation Instructions
2.2 Battery Pack Insertion
B
C
A
A.
Battery connector
B.
Enroll button
C.
Self-test switch
CAUTION!
Risk of explosion if battery is replaced by an incorrect type.
Dispose of used battery according to manufacturer's instructions.
1
1.
Connect the two connectors in their respective sockets.
2
2.
Connect the battery connector and insert the battery.
Figure 3: Battery Pack Insertion
2.3 Cover Closure
See Figure 4.
1.
Put back the plastic cover.
2.
Secure with screw.
Figure 4 - Cover Closure
3
3
3
3. ENROLLMENT
. ENROLLMENT
. ENROLLMENT
. ENROLLMENT
Refer to the PowerMaster panel's Installer Guide and follow the procedure under the
"02:ZONES/DEVICES"
option of the Installer Mode.
A general description of the procedure is provided in the following flow chart.
Step 1
Step 2
Step 3
Step 4
Enter the Installer Mode and select
“02:ZONES/DEVICES”
Select
“ADD NEW DEVICEs”
See Note 1
Enroll the device or enter the
device ID
Select the siren number for
the new siren
02:ZONES/DEVICES
ADD NEW DEVICES
ENROLL NOW or
ENTR ID:XXX-XXXX
SR1:Siren Indoor
ID No. 400-XXXX
MODIFY DEVICES
Step 5
Step 6
Step 7
Step 8
Configure Location, Zone Type &
Chime parameters
Enter
“PARTITIONS”
.
See Note 2
Assign partitions to the siren by
pressing the
,
and/or
buttons on the
panel
Select the
“DEV SETTINGS”
option and refer to the section
below to configure the siren
parameters.
SR1.LOCATION
SR1.ZONE TYPE
SR1.SET CHIME
SR1.PARTITIONS
SR1:P1
P2 P3
SR1:DEV SETTINGS
means scroll
and select
Notes:
[1] If the siren is already enrolled you can configure the siren parameters and assign partitions via the
MODIFY DEVICES
option – see Step 2.
[2]
PARTITIONS
will appear only if PARTITIONING was previously enabled in the panel (for further details, see "Partitioning" in the PowerMaster
Installer Guide).
[3] When there is an alarm, the siren will sound regardless of partition assignment.