SMD-426, SMD-427
D-302758
11
Battery cover
Open battery cover and connect the battery to its terminals.
3 volts CR17450
Tamper
switch
Enroll
button
Figure 3b.
Battery Connection for CR17450
Note:
When the battery first makes contact, the alarm horn
may sound for one second. This indicates that the battery
is connected properly.
Close the cover, then press the test button (see fig. 1) for
about 2 seconds, (for further details see par. 3.6).
3.6 Resetting the Transceiver Module
The detector has a wall / rear tamper switch to alert
removal of detector. The tamper switch actuator, extending
through a hole in the base (see Figure 3), is pressed
against the bracket when the unit is attached to the bracket.
Removal of the unit from the bracket will cause the switch
contacts to open, creating a tamper event, which will be
reported by the transceiver to the control panel.
4. ENROLLMENT
Refer to the PowerMax10-G2 Installer Guide for the device
enrollment procedure.
5. MODIFY DEVICE SETTINGS
This section describes how to configure the parameters of the smoke detector from the PowerMax10-G2 control panel.
To Modify the Smoke Detector Device Settings
Refer to the PowerMax10-G2 Installer Guide and perform the procedure for Adding A Wireless Device (section 4.4.2), or,
Modifying a Device (section 4.4.5). Then continue below to modify the device settings.
1.
When the PowerMax10-G2 display reads [
DEV SETTINGS
], press
OK
I
.
The PowerMax10-G2 display will read [
Burglary Siren
].
OK
I
2.
Press the
OK
I
button.
The PowerMax10-G2 display will read [
enable
].
OK
I
3.
Press the
or
button to select between "
enable
" and
"
disable
", for example, "
disable
".
or
4.
Press
OK
I
to confirm the selection.
The PowerMax10-G2 display will revert to [
Burglary Siren
].
OK
I
5.
Press the
button.
Burglary Siren
Burglary Siren
disable
disable
enable
