Figure 9. Surface Mounting
Surface Mounting
(
see Figure 9
)
1.
Drill two holes in the mounting surface and secure the base with two screws.
2.
For back tamper (optional) drill two holes and secure with two screws.
3.
Position the PCB in its proper location within the base.
4.
Insert the screw to secure the cover with the base.
A.
Mounting surface
B.
Break-away segment
Attention!
The back tamper switch becomes functional only when the break-away
segment is secured to the wall with a screw.
Notes:
1.
After mounting, be sure that no gaps remain in the detector housing. For example,
in the area around the screw holes.
2.
Remove the battery using your fingers, and not with a screwdriver.
3.
Back
Tamper
must
be
used for EN
installations.
Caution!
Risk of explosion if battery is replaced by an incorrect type. Dispose of used
battery according to manufacturer's instructions.
2.3. Bracket Mounting
Note:
Mount the detector so that its orientation is perpendicular to the expected intrusion path.
Note:
When mounting using the bracket, the back tamper becomes
inoperative.
1.
Drill two 7 mm (1/4") holes at the marked locations
Figure 10. Drilling Holes
1.
Drill two holes in the mounting surface.
2.
Secure the bracket with two screws.
A.
Mounting surface
B.
Top view
Note:
The bracket provides two mounting options
For optimum angle coverage:
* use these two holes to shift the coverage angle by 5° away from the
wall
** use these two holes to shift the coverage angle by 10° away from
the wall
Figure 11. Mounting Bracket to Surface
1.
Place the base slots over the two bracket pins.
D-303370 CLIP PG2 Installation Instructions
3