6
Your measurements are not lost when installing newer versions or uninstalling. All
measurements will always remain in your document folder. If you want to remove all
your measurements go to th
e ‘Light Inspector’ folder and delete them manually.
Typical folder location:
C:\Users\
’Username’
\Documents\Viso Systems\Light Inspector
Or if stored in dropbox:
C:\Users\
’username’
\Dropbox
Connecting power
The LightSpion comes with a standard IEC power-in connector and with a standard
euro power cable, but any power cable can be used as the LightSpion supports any
outlet voltage from 90-260VAC.
The power-in connector supplies power both to the goniometer motor and to the
power analyzer and then subsequently to the measured light source. It means that
the power is identical to the one of the measured light source (unless the latter is
power with an external power supply).
AC power supply cable plug
Warning: Risk of an electric shock! Plug installation shall be performed by a qualified
electrician.
A grounding-type (earthed) power plug that fits the local power outlet must be used.
You can acquire an IEC power cable with a suitable grounding-type plug from most of
consumer electronics stores.
When installing the plug connect pins as follows:
•
Blue wire to
neutral
•
Yellow and green wire to
grounding
(earth)
•
Brown wire to
live
Connecting USB
The LightSpion is connected to the computer using a USB connector type B.
A 2 m USB cable type A to B is included in the LightSpion case, however any USB
cable supporting USB2.0 can be used.
The USB provides communication and power to the LightSpion’s ma
in board
processor, power analyzer and photo spectrometer, meaning that the photo
spectrometer can be used only with the connected USB.
Start the Viso Light Inspector software after having connected the USB; the
connection to the LightSpion will be established automatically. A successful
connection is shown with a green “Connected” icon in the upper right corner of the
Viso Light Inspector software.
You can connect and disconnect the USB without restarting the Viso Light Inspector
software, as the connection is always established automatically as soon as the USB
connector is plugged in and vice versa.
Neutral
Ground/Earth
Live
