UltraReceiver User Manual
Main Display
Issue No: 3
Page: 26
Ref: ULRX-ASUM-700X
Copyright © 2018 Vislink plc
The receiver has a 10/100M Ethernet port (see Section 3.13.11) that can connect to any
standard Ethernet network using a standard or crossover Ethernet cable.
To make individual UltraReceiver configuration easier, access the inbuilt menu system
using the integrated webserver. To connect to the webserver over the RJ45 network port,
follow this procedure:
1.
Power up the UltraReceiver and wait for the unit to fully boot.
2.
Connect the UltraReceiver and PC running a web browser, either directly, using an
RJ45 network cable, or via a router.
NOTE: Depending on the age of your PC, you may require a crossover RJ45 cable. In most
cases, modern PCs and routers include auto-switching (Auto MDIX) so either type of
RJ45 cable are suitable.
3.
If you wish to use non-default settings, configure the IP addresses from the
UltraReceiver front control panel:
a.
MAIN MENU > UNIT SETUP > CONTROL
b.
Configure the IP address and Subnet Mask and press Enter each time to save:
NOTE: The below values are default values.
NOTE: The network port only supports static IP addressing.
IP address:
192.168.000.210
Subnet mask: 255.255.255.000
Gateway:
192.168.000.001
4.
If using the default UltraReceiver settings, modify the network settings of your PC to
use the same subnet mask and an address from the same subnet e.g.:
PC subnet mask:
192.168.000.100
PC subnet mask:
255.255.255.000
NOTE: The Default Gateway address is not required, so can be set to some address in the
subnet range.
NOTE: If you want to use a particular subnet address, then you can edit the HCAM network
parameters via the front panel menu as required.
5.
Once you have configured the IP ports and connected the RJ45 cable, an LED
illuminates on the HCAM RJ45 connector to indicate a connection.
1.
From your chosen browser, in the address bar, enter the IP address for the HCAM
unit. The factory default address is:
http://192.168.000.210
2.
After a short delay, the UltraReceiver menu displays on the webpage (see Figure 5-1).
3.
Now make your required configuration changes to the unit using the webpage.
