Page 7
HDR-1000 User and Technical Manual
Main Control Panel
The Main Control Panel is located on the top of the unit and
provides both controls and indicators. The panel contains an
LED Dark Timer
that turns OFF LEDs after a delay. (Delay
time can be set in Web Browser Control Interface section.)
All LEDs are momentarily activated when the unit is fi rst
powered ON.
Indicator LEDs
The Indicator LEDs are located on the Main Control Panel
on top of the unit. Each of these is described in turn.
SNR LED
- This LED illuminates when you choose SNR
with the RSSI/SNR button. Dark = RSSI
DEMOD UNLOCK LED
- Illuminated if the receiver is
unable to demodulate the incoming RF signal.
DECODE UNLOCK LED
- Illuminated if the receiver is
unable to decode the incoming MPEG signal.
CRYPTO LED
- Illuminated if the receiver is decoding the
encryption code associated with the incoming RF signal (if
enabled).
ALARM LED
- Red when an alarm occurs; otherwise dark.
The ALARM LED illuminates when an alarm is detected
during normal operation.
RSSI LED
- This LED illuminates when you choose RSSI
with the RSSI/SNR button.
Multi-LED Display
- Indicates which preset is being used.
The LEDs remain lit until another option button is selected or
until the LED Dark timer deactivates the display illumination.
Also displays RSSI/SNR or Audio level (setting dependent).
Indicator
Description
Suggested Actions
DEMOD
UNLOCK
Illuminates if the demodulator
becomes unlocked due to the
loss of the received signals
from the transmitter.
Verify the proper preset is selected.
Verify the antennas are properly connected
and positioned.
DECODE
UNLOCK
Illuminates if the decoder
becomes unlocked due to the
loss of the received signals
from the transmitter.
Verify the proper preset is selected.
Position the antennas to optimize the
SNR reading.
ALARM
Illuminates to indicate that there
is an alarm or fault detected.
Connect to the Ethernet interface to diagnose
the source of the alarm.
