visiplex VP-4, Programming & User Manual

Page: 3 / 4

VP-4 Pager – Programming User Guide – Version 1.01
3
Note : The section below applies to pagers with versions prior to 8108-V4 .
Manual Programming Mode
The manual programming provides access to the settings of 6 capcodes, baud rate, frequency and data polarity.
1.
Insert a battery and turn on the pager.
2. a. Press the
▲
key until the graphic menu is displayed.
b. Press the
►
key until the display shows ON/OFF PAGER .
c. Press the
▲
key to turn off the pager.
3. Press and hold both the
◄
and
►
keys until the password screen is displayed.
4. Enter the password using the
►
key to select a digit and press
▲
key to navigate to the next password digit. After the 4th digit
was entered, press the READ/ON-OFF key.
Note : Default password is 1141 .
Changing Capcodes
1.
Enter the manual programming mode as described in the Manual Programming Mode section. The display will show
ADSYSBFRQT .
2. a. Verify that the AD field is underlined or use the
►
key to navigate the cursor to the AD field.
b. Press the
▲
key.
3. The display will show “ 1: CCCCCCC 0 ”, where CCCCCCC is the capcode already programmed in to the pager.
The first digit label represents the number of the capcode (capcode ID) to be edited. For example, 1 represents capcode #1 and 6
represents capcode #6.
4. Select the ID of the capcode to be edited using the
▲
key.
5. Press the
►
key. The cursor will move to the CAPCODE field.
6. a. Use the
▲
key to enter a respective capcode digit for each underlined digit in the capcode field.
b. Press the
►
key to navigate to the next digit.
c. After the rightmost digit was entered, press the
►
key. The cursor will move to the ON/OFF field.
Note
: Standard capcode range is from 0000008 to 2097151. Invalid capcodes will be rejected.
7. Use the
▲
key to toggle between 0 (ON) and 1 (OFF) for the selected capcode. If you wish the capcode to be active, select 0
(ON).
8. Press the
►
key. The cursor will move to the capcode ID field.
9. To program additional capcodes, press the
▲
key to select the capcode to be programmed and repeat steps 5-8 for each capcode.
Otherwise, press the READ/ON-OFF key to return to the main programming menu.
10. a. If additional programming is not required, press the
►
key until the cursor is under the QT field.
b. Press the
▲
key exit the programming mode and return to standard operation mode.