visiplex VP-4, Programming & User Manual

Page: 2 / 4

VP-4 Pager – Programming User Guide – Version 1.01
2
Changing Baud Rate and Polarity
1.
Enter the manual programming mode as described in the Manual Programming Mode section. The display will show ABFLPq .
2. a. Press the
►
key to position the cursor under the B field.
b. Press the READ/ON-OFF key.
3. The display will show a sequence of characters in the following format: " BPS BBBB PPP " . Use the
◄
and
►
keys to select the
preferred setting. Below is the description of each field:
BBBB – Baud Rate 512 bps, 1200 bps, 2400 bps
PPP – Polarity Nrm – Normal, Inv – Inverted
4. Press the READ/ON-OFF key to return to the main programming menu.
5. a. If additional programming is not required, press the
►
key until the cursor is under the q field.
b. Press the READ/ON-OFF key to exit the programming mode and return to standard operation mode.
Changing Frequency
1.
Enter the manual programming mode as described in the Manual Programming Mode section. The display will show ABFLPq .
Note
: If the F field in not displayed on the pager’s programming menu, the manual frequency programming feature is not
supported by the pager.
2. a. Press the
►
key to position the cursor under the F field.
b. Press the READ/ON-OFF key.
3. The display will show “FREQ: FFF.FFFFF ”, where FFF-FFFF is the frequency programmed in to the pager.
4. a. Use the
▲
key to enter a respective frequency digit for each underlined digit in the frequency field.
b. Press the
►
key to navigate to the next programmable digit.
c. After the rightmost digit was entered, press the
►
key. The cursor will return to the first available frequency digit.
Note : The frequency must be within the frequency band supported by the pager (refer to the label at the back of the pager).
Invalid frequency or a frequency not within the band supported by the pager will render the pager inoperable.
5.
Press the READ/ON-OFF key to return to the main programming menu.
6. a. If additional programming is not required, press the
►
key until the cursor is under the q field.
b. Press the READ/ON-OFF key exit the programming mode and return to standard operation mode.
Changing Password
1.
Enter the manual programming mode as described in the Manual Programming Mode section. The display will show ABFLPq .
2. a. Press the
►
key to position the cursor under the P field.
b. Press the READ/ON-OFF key.
3. a. Use the
▲
key to enter a respective password digit for each underlined digit in the password field.
b. Press the
►
key to navigate to the next programmable digit
4. Press the READ/ON-OFF key to return to the main programming menu.
5. a. If additional programming is not required, press the
►
key until the cursor is under the q field.
b. Press the READ/ON-OFF key exit the programming mode and return to standard operation mode.