page 17
3.3
Display of status of MCM unit
The display indicates the status of the satellite to be tracked.
All status reports displayed are reports from the dome to the MCM unit.
Status : Searching for Limit : The system searches for its reference points
Searching for Sat : The system searches for the satellite
Tracking
: The system tracks the satellite
Peaks
: Optimising signal strength
Carry out tracking : The system positions itself
Stand-by
: The system enters stand-by mode
3.4
Display of MCM unit error codes
Various texts will appear on the display to report errors
Error Codes:
E
: No Limit.
E
: No Signal.
E
: Comm error.
E
: Firmware not found.
E
: Error during update
E
: Usb disk not found
E
: No Tuner.
3.5
Explanation of Error Codes
E
: No Limit.
The system can not find its reference positions. Reset the system.
If "No Limit" appears again on the display, contact your dealer.
E
: No Signal.
The system is not detecting any signal from the LNB. In this case the LNB may
be defective, or there is a poor connection with one or more of the coax cables
in the system.
E
: Comm error.
There is no communication between the MCM unit and the dome. Check the
wiring between the MCM unit and the dome.
E
: Firmware not found
No software is installed on the system. Reset the system.
Install software using USB stick.
