VL-SERIES LED WORK LIGHT
WARNING: Bolts, Nuts, and Washers are Stainless Steel.
DO NOT USE Pneumatic or Electric Tools to Tighten and
Loosen. The Hardware Will Permanently Lock Together.
WIRING INSTALLATION INSTRUCTION
1.
If supplied with the light is a 3” Pigtail, Part (P1),
Connect
the positive red wire Part (R1), and negative black wire Part
(B1), into an existing power source.
TIP:
For complete application guide see website
*actual light may vary
COMPONENTS KEY
Part (P1) Pigtail
Part (R1) Power Wire
a. 9-32V DC Positive (+) Input Wire
Part (B1) Ground Wire
a. 9-32V Negative (-) Input Wire
(+) Red (R1)
(-) Black (B1)
WIRING DIAGRAM (IF APPLICABLE)
(P1)
To Light
MOUNTING INSTALLATION INSTRUCTION
1.
Determine where the light/lights will be placed.
2.
Place mounting bracket with light to desired location. Using
a marker or pick tool, mark the center point of the bolt hole
on the mounting surface.
3.
Set the light aside. Drill out a large enough hole to fi t the
[M5] bolt Part (B1).
4.
Line up the mounting bracket with the hole you just drilled,
slide the [M5] Bolt (B1) through both.
5. On the other side of mounting surface slide the [M5]
Washer Part (W1) and [M5] Nylock Nut Part (N1) onto the
[M5] Bolt (B1). Tighten Nut & Bolt to desired tightness.