Press 00 new code # repeat new master code #
Note: Master Code length: 6~8 digits
8.1 Change the master code
5
7.4 User Optional Setting
1. Master code must be 6-8 digits, Anti-duress PIN must be 8 digits, user PIN is
4-6 digits.
2. The user ID number is 1-4 digits ,which can be any number among 1-2000,Invalid
0 can be omitted; card number must be 8 or 10 digits, if the card number is
less than 8 or 10 digits, input 0 before the card number.
3. Door open time is 0-99 second,0=50mS
4. When register one card user into the device, the device will automatically generate
a PIN 1234, but this PIN 1234 can’t open the door, you need to change PIN
1234 to other numbers to open the door.
5. When an invalid master
pin is pressed, the device will go back to the standby
status after 5 seconds, when a valid
master pin is entered, it will go back to
standby status after 30 seconds.
6. In operating the keypad, pressing # means to confirm the input digits ,In operation
of a cycle adding or deleting cards, pressing # means to end the cycle
operation and back the up operation; pressing * means to exit the operation.
7. When add a series cards, this unit will make the ID number and card number as
initial value; after adding one user, then it will increase the ID number and
card number automatically, until the specified number of card is added.The card
number must be consecutive card quantity is between 1-2000.
8. Working mode and keypad transmission format have been set before shipping,
customer can change according to requirement, but cannot be restored to
factory
settings by initialization.
9. When users is registered successfully, LED will turn green.
Instruction:
8. Administrator Setting
Administrator setting on keypad
Press Master code # factory default:999999
*
0 #
41
42
43
1 #
Default 1
Default 1
Default 2
0 #
1 #
0 #
1 #
2 #
Orange
Setting
Remarks
Functions
Stand
by
Red
Flash
*
Master
Code
Red
Menu
Red
Master
code#
(Code
length:
6-8
digits)
Buzzer will be in silence except
enter the programming mode
Buzzer will sound when press
the key
Disable keypad backlight
Enable keypad backlight
Automatic mode
LED is constantly flash when
stand-by status
LED Light Disable when
stand-by status
