© 2017
w w w . c l a s s i c e x h i b i t s . c o m
Step 3 of 7
Order #XXXXX
Left to Right Backwall & Attachments
4
5
2
3
8A
Screw
Cap
Left Backwall
Right Backwall
Steps:
1) Attach
Panels
to Verticals [2/3] and [4A/5A], using screw caps.
2) Attach Wing panels to A10 clamps. See
Wing Attachment
detail.
3) Attach Light to top of Backwall. See
Light Connection
detail.
4) Attach Headers to Extrusions [3A] & [8A]. See
Header Attachment
detail.
5) Attach Graphics to Velcro on back of Backwall. See SEG
Graphic Installation page for instruction.
3A
2A
Slide A10 clamp into
groove of Extrusion.
When desired location
is found, tighten
Set Screw to secure.
Set
Screw
A10
Tighten Black Plastic
Set Screw to secure
Wing in place.
Wing Attachment
Keep A10 clamps
attached to Verticals
Black
Plastic
Set Screw
Light Connection
Connect Lights to
Horizontal where
desired and
tighten in place.
*
*
*
*
Connector
Header Attachment
Cap
Header
Standoff
Slide Connector into groove of Vertical Extrusion. Tighten
set screws to secure in place. Screw Standoff into
Connector. Place Header between Standoff and Cap,
then screw Cap to tighten in place.
*
*
Header
Header
4A
5A
