w w w . c l a s s i c
e x h i b i t s . c o m
Step 3
Page 3 of 4
866.652.2100
© 2009
WHEN DISASSEMBLING ALUMINUM EXTRUSION, TIGHTEN ALL
SETSCREWS AND LOCKS TO PREVENT LOSS DURING SHIPPING
Order #xxxxx - Sacagawea -
*Note:
Curved extrusion
[10] and horizontal [11]
must stay assembled
when shipping.
Item
10
11
11a
Description
30.2” Curved Extrusion
12.184”w Horizontal Extrusion
Flange Plate
Qty.
1
1
1
Steps:
1) Connect horizontal extrusion [11] to curved extrusion [10].
2) attach assembled counter support [10/11] to vertical where indicated.
3) Attach flange plate [11a] to top of curved extrusion [10] as shown.
4) Attach counter atop support, see counter top attachment detail.
5) Attach wings to clamps as shown.
6) Attach round sign to backwall frame where indicated.
7) Attach literature racks where indicated.
Counter Top Attachment
Insert screws located on underside
of counter into holes on flange plate
and secure with wing nuts.
Wing Nut
Screw
10
11
11a
Slide A10 Clamp
into groove
of square extrusion.
When desired location
is found, tighten
set screw to secure.
Set-
Screw
A10
Tighten black plastic
set screw to secure
Wing in place.
Black Plastic
Set-screw
Wing Attachment
*Note: A10 clamps must
stay attached with verticals
Graphic
Cap
Standoff
Barrel
Slide connector on back of standoff
barrels into groove of extrusion
and twist to secure in place. Secure graphic
to standoffs using screw caps.
Graphic Attachment
Monitor Mount
Attachment
V4 Connectors
Attach monitor mount back plate
to connectors using screws provided.
*
*
Attach connector piece to rack
as shown. Then connect
assembled literature
rack to vertical extrusion.
Literature Rack Attachment
Tighten Lock
to Secure
Counter, Wing and Sign Attachment
