VISION X XPI LIGHT BAR
WIRING INSTALLATION
1. If applicable, disconnect/locate the existing connection on your vehicle,
otherwise install a new power source or purchase a wiring harness.
2. Strip both the red and black Pigtail wires, and your power source so that
roughly 1/2” is exposed on each wire.
3. Connect the positive (red [+]) Pigtail wire to the positive wire on your
power source via method of your choice.
4. Repeat the above step for the negative Pigtail wire (black [-]) as well.
5. Now that the wire is connected to the pigtail it is ready to plug into the
LED light for use.
INSTALLATION SUGGESTIONS
1. Vision X recommends professional installation for LED lights.
2. Those less experienced at installing LED lights are recommended to
purchase a wiring harness that connects directly to your vehicle battery.
WARNINGS
As with many other high-tech products, this VISION X LED requires a bit of
attention before you can use it. Please read the accompanying information
carefully fi rst.
1. Don’t stare directly into the light or shine directly into the eyes of another
person as this may cause temporary loss of vision.
2. Never disassemble the products, as all parts must be factory serviced to
insure proper operation.
3. Don’t interchange the parts inside this light with other products.
4. The LED light is to be mounted on the vehicle only in a vertical, bottom
mounting, or in a suspended position.
5. After turning on the light, the body might be hot enough to warrant a burn
risk. Be careful when you touch the body after turning on the light for a
long period of time.
6. Use the supplied wire harness for electrical installation.
7. The LED light must not adversely affect the performance of low beam,
high beam, engine cooling or the driver’s view.
COMPONENTS KEY
Part (P1): Pig Tail With Deutsch Connector
Part (P2): XPI LED Light Bar
TESTING THE LIGHT
1. After all connections have been made start your vehicle and test your
switch to make sure it turns on the light.
2. Make sure the angle of your light is correct, otherwise adjust the light
angle again.
3. Make sure no wire or other components of the harness are exposed to
water spray, excessive heat, or moving parts.
TIP:
Vision X recommends checking each bolt and nut, as well as the
connectors after driving your vehicle for an extended period of time to ensure
that each light is securely mounted.
*Harness Available
PIG TAIL WIRING INSTALLATION DIAGRAM
*
PROFESSIONAL INSTALL RECOMMENDED*
-
+
(P1)
(P2)
