VISION X XPI LIGHT BAR
MOUNTING INSTALLATION FOR WINGS (END CAPS)
1. Start by placing two (2) rubber grommets [W2] on each side of the LED
bar over the appropriate threaded bolt holes. (See Figure 1)
2. Place the mounting wings [W1] over the rubber grommets and insert the
wing bolts [W3].
3. Use a phillips screwdriver to tighten the wing bolts [W3], starting with the
top bolt fi rst. (See Figure 2)
4. Place the light bar on the location where it will be mounted.
5. Determine where the 5mm bolt [M1] will be placed for each wing, and
mark where the bolt location will be for each side.
6. Drill a hole for the 5mm bolt.
7. Line the light bar wings over the drilled hole and slide the 5mm bolt
through the wing as well as the drilled hole.
8. Slide the washer [M2] on the opposite side of the drilled hole followed by
the nut [M3], and screw until secured.
MOUNTING INSTALLATION FOR FEET
1. Start by setting the light bar in the location that you plan to mount it in.
Mark each end of the light bar and measure the length.
2. Depending on the length of your light bar, you will have a certain
number of mounting feet [F1] included in the packaging. These feet fi t
into grooves on the back of the light bar.
3. Place each mounting feet [F1] (with bolt head pointing into light bar) into
the feet grooves on the back of the light bar.
4. Mark the location of each mounting feet on your vehicle. Drill holes for
each. The feet can slide inside the grooves, letting you fi ne tune the
location.
5. Remove the nut from the feet bolt, and place the light bar onto your
vehicle, line up the bolts with the previously drilled holes.
6. Securely tighten the nut to the mounting feet bolt.
LIGHT ANGLE ADJUSTMENT
1. For the Wing Mount option, simply loosen the bottom wing nut (Fig. 4) on
each end and rotate light bar to desired angle. Fasten when completed.
2. For the Feet Mount option, use the provided allen wrench to loosen both
the Allen bolts on each side the light bar. Once desired angle is achieved,
tighten the bolts.
3. A good reference point is at 20 ft; the top of the beam should be 3” down
from center of light (with the light bar at dead center). Tighten light and
enjoy.
1
2
3
4
7
5
8
6
9
Qty: 1
Qty: 1
Qty: 2
Qty: 1
Qty: 2
Qty: 4
Qty: 2
Qty: 4
LED Light Bar
Pigtail
Hex Head Bolt
(5mm)
Allen Key
(5mm)
Wing Mounts
(Side Mount)
Rubber Grom-
met (Wings)
Mounting Feet
(Bottom Mount)
Nylock Nut
(5mm)
Wing Bolts/
Nuts/Washer
MOUNTING
WIRING
PART (M1)
PART (M5)
PART (W1)
PART (W2)
PART (F1)
PART (M3)
PART (W3)
QTY
Varies
MOUNTING FEET BY NUMBER OF LEDS
6LED
9LED
12LED
15LED
18LED
21LED
24LED
27LED
# of
Feet
2
3
4
5
5
6
6
7
