background image

 

Solstice Solo Prime 

Installation Instructions 

 

WARNING! – Only use included wiring to wire the Solstice Solo Prime. Even though 
the plug is the same as other Vision X wiring, the Solo series has unique circuitry 
that can easily be damaged with wiring other than the included pigtail. 
 
 
 
 
 
 

Package Contents; 

1.  Solstice Solo Prime Series Pod 
2.  Wiring Pigtail with Deutsche Connector 
3.  Universal Stud Mount 
4. Allen 

Wrench 

 
 
 

Required Tools; 

1.  ¼” Drill Bit 
2.  10mm Socket and Ratchet 
3.  10mm Open End Wrench 
4.  (2) 16 Gauge Barrel Crimps or Soldering 

Iron, Solder and Heat Shrink 

5. Crimper 
6. Wire 

Stripper 

7.  Included Allen Wrench 

 
Mounting Instructions; 

1.  Drill ¼” Hole in desired mounting location. 

a.  Note – The center of your hole will be the exact center of the light. Make sure to measure the 

location of your hole before drilling. 

b.  Note – If you are linking multiple pods together using the included Omni-Link connector, carefully 

read linking instructions on the bottom of the next page before selecting placement of mounts. 

2.  Insert stud mount through the ¼” hole and tighten the nylock nut with a 10mm socket or wrench to a 

maximum torque of 20 ft/lb. 

a.  Note – DO NOT use air impact tool as they will damage the stainless threads. 

3.   Remove adjustment set screws if installed on adjustment bracket. Tighten the adjustment nylock snug 

against the bracket and aim the light to desired position. After the light is aimed, tighten the adjustment 
bolt and nylock to a maximum torque of 20 ft/lb. If desired insert and hand tighten adjustment set screws 
for use in high vibration scenarios. 

Wiring Instructions; 

The Solstice Solo pod draws .75 amps at 12 volts. A relay harness is always recommended in vehicle 
applications running more that (5) Solo Pods. Vision X does offer these for sale. A maximum of 25 Solo pods per 
30 amp 12 V DC relay is recommended. If the vehicle does not have a battery one will be needed. Battery packs 
are also available for purchase. For stationary applications, 9-50 V DC is required to operate the pods. 
 

Note:

 The yellow\green wire on the light is the prime drive control wire, used for controlling dimming 

functions. Do not connect this wire to anything other than a Vision X Prime Drive Dimmer Controller. 
Attaching this wire to battery power or ground may cause damage to the light and void your warranty. 

 

1.  Before making any connections, unplug all of the Solo pods to avoid damaging the internal electronics. 
2.  Each Deutsche connector pigtail consists of a red and black wire. Red is your positive (+) input and Black 

is your negative (-) wire input. 

Washington Warehouse 

901 Algona Blvd N. 

Unit F 

Algona, WA 98001 

Ph: 888-489-9820 

Fx: 253-218-2905 

Arizona Warehouse 

6501 E. Greenway 

Suite 103-542 

Scottsdale, AZ 85254 

Ph: 800-994-4460 

Fx: 480-922-5655 

 

www.visionxusa.com 

Page 1 of 2 

 

Reviews: