VISION X
ADDITIONAL INFORMATION
If needed, additional information and related products, as well
as a digital copy of these instructions, can be located online at
www.visionxusa.com
WARNING: Bolts, Nuts, and Washers are Stainless Steel.
DO NOT USE Pneumatic or Electric Tools to Tighten and
Loosen. The Hardware Will Permanently Lock Together.
LIGHT ANGLE ADJUSTMENT
1. Use the 5mm Allen Key Part (A1) to loosen the Allen Head
Bolts Part (B2) on each light.
2. Adjust the light until you have your desired angle.
3. Tighten the Allen Head Bolts to hold the desired position.
MOUNTING INSTALLATION INSTRUCTION
1. Determine where the light/lights will be placed.
2. Place mounting bracket with light to desired location. Using
a marker or pick tool, mark the center point of the bolt hole
on the mounting surface.
3.
Set the light aside. Drill out a large enough hole to fit the
[M8] bolt Part (B1).
4. Remove the mounting bracket from the lights by
unscrewing the (2) 5mm Allen Head Bolt Part (B2).
5. Line up the mounting bracket with the hole you just drilled,
slide the [M8] Bolt (B1) through both.
6. On the other side of mounting surface slide the [M8]
Washer Part (W1) and [M8] Nylock Nut Part (N1) onto the
[M8] Bolt (B1). Tighten Nut & Bolt to desired tightness.
7. Reassemble the light back on the mounting bracket by
reapplying the 5mm Allen Head Bolts (B2). Tighten to
desired tightness.
