VISIONXLIGHTING.COM
COMPONENTS KEY
Part (R1 & R2) Relay
Part (W1 & W3) Power Wire for Relay Coil
a. 9-32V DC Volt Positive (+) Input Wire
Part (W2 & W4) Ground Wire for Relay Coil
a. 9-32V DC Negative (-) Input Wire
Part (C1 & C2) Deutsch Connectors for Lights
a. Attached to 9-32V DC Positive (+) Power Wires
Part (S1) Switch
Part (P1) Switch Plug
WIRING INSTALLATION INSTRUCTION
1. Find a suitable place to mount Relays Part (R1 & R2) leaving enough room for
Power & Ground wires Part (W1,W2,W3,W4) to reach the battery & the Deutsch
connectors Part (C1 & C2) to reach the lights. Mount Relays.
2. Run Power wires (W1, W3) & Ground wires (W2 , W4) to the battery. Connect the
Power wires (W1 , W3) to the Positive (+) battery terminal and connect the Ground
wire (W2 , W4) to the Negative (-) Battery Terminal.
3. To connect the Halo wire Part (H1) tap the yellow wire to an existing power source or
on its own auxiliary switch.
4. Run the Deutsch Connector wiring, (C1 & C2) to each light and plug in. It doesn’t
matter which Deutsch Connector plugs into which light.
5. Disconnect the Switch Part (S1) at the white Plug Part (P1) and run the wire through
the vehicles fire wall to desired mounting location inside the Cab, [using a factory
rubber or plastic grommet is suggested].
6. Drill the hole to the required size for the Switch (S1) and mount to desired position.
7. Reconnect the Switch (S1) to the Harness and Test Light.
WIRING DIAGRAM
(H1)
Halo wire
HALO WIRE:
