R2100
Assembly
Step 6 • Console Mast
1:
Unfold the RPM Sensor Wire (64) that is folded into the Frame Console
Mast bracket. Straighten this cable and remove any kinks by drawing the
cable through your fingers.
2:
Slide the Rubber Console Mast Cover (88) onto the Console Mast (101)
until it is above the first waterbottle screw.
3:
Holding the Console Mast (101) above the Frame Console Mast Bracket,
guide the RPM Sensor Wire (64) and Lower Magnet Shift Cable (66)
through the Console Mast while simultaneously sliding the Console Mast
onto the frame bracket.
4:
Bolt the Console Mast (101) to the frame using the six Console Mast Allen
Bolts (182). Make sure these bolts are very tight. Now slide the Rubber
Console Mast Cover (88) back down to cover the bolt heads.
Step 5 • Pedals
1:
Identify the left and right Pedals (152) and the left and right Pedal Straps
(199). Attach the correct straps to each pedal, then thread each Pedal into
the correct left and right crank arms and tighten.
NOTE:
It is very important to FULLY TIGHTEN each pedal. Failure to do
so will result in loosening and NOISE.