21
Product Use
Start up
- Turn off the engine and remove the key from ignition.
- Check to see if the SD card is inserted into the unit.
- Turn on the engine
- When the engine is turned on, the system boot starts with the program installed
in the SD card and a voice notification will be announced.
- Then the REC and GPS lamps will turn on.
- The REC lamp will turn blue while blinking.
- The GPS lamp will turn red if no signal and blue if receiving signal.
- The GPS connection may take a couple of seconds to several minutes, depending
on the location of the vehicle.
- Connection or disconnection of the optional camera(VD-300WR) to or from the
main unit will reboot the system automatically to initialize 1ch or 2ch recording
mode.
