Vision Aerial SwitchBlade-Elite, Flight Manual

Page: 39 / 60

39
RETURN TO LAUNCH
Return to Launch (RTL) mode is both a flight mode and a failsafe protocol. When the RTL
switch is activated (and GPS lock is present), by factory programming the SwitchBlade-Elite will
deploy its landing gear, climb to 15 meters above the launch location, return on a direct path,
hover for 5 seconds and then begin a slow landing sequence. It is recommended to use a 6
meter diameter or larger launch/land environment, as the accuracy of the GPS system can vary
by up to a maximum of ±2.5m.
Return to Launch mode is initiated by moving both switches furthest near to the right control
stick.
It is important to note that if the flight environment is significantly higher than the launch location
the 15m climb altitude may not be adequate. If 15m is not adequate for your flight environment
the setting can be easily changed in the parameters section of the Mission Planner software.
Additionally, if the launch location itself is moving, say from a moving vessel, it is best to avoid
the use of Return to Launch.
Return to Launch mode is also a failsafe protocol, and will be activated automatically should the
SwitchBlade-Elite loose communication with the controller.
*NOTE:
If at any time during a RTL sequence the pilot wishes to retake control, they may do so by
simply moving the flight mode switch to another flight mode. If the RTL was executed
automatically due to a lost link with the controller, control can be re-established once the
transmitter regains the link and a flight mode switch is toggled from any flight current mode to
any other flight mode.