12A
Software version
Press the
MENU
button up to when the
is blinking on the display. Press the
ENTER
button and the display will show the version of software of the unit. To go back to the functions
press the
MENU
button again.
4. How To Control The Unit
You can operate the unit in two ways:
1. By master/slave built-in preprogram function
2. By DMX controller
No need to turn the unit off when you change the DMX address, as new DMX address setting will
be affected at once.
4.1 Master/Slave Built In Preprogrammed Function
By linking the units in master/slave connection, the first unit will control the other units to give an
automatic, sound activated, synchronized light show. This function is good when you want an
instant show. In Master/Slave mode, the first fixture whose DMX input jack has with nothing
connect will be master automatically, set other units to slave mode
4.2 DMX Controller
Use universal DMX controller to control the units, you have to set DMX address from 1 to 512
channel so that the units can receive DMX signal.
Press the
MENU
button up to when the
is showing on the display. Pressing
ENTER
button
and the display will blink. Use
DOWN
and
UP
button to change the DMX512 address. Once the
address has been selected, press and keep
ENTER
button pressed up to when the display stops
blinking or storing automatically 8 seconds later. To go back to the functions without any change
press the
MENU
button again.
