Cable
Balls
Connect cables to your Displays,
routing them down the rear of the pole.
Push the cables into the slots, using
either the Cable Balls or Cable Clips
to secure them to the pole as shown.
Note:
Ensure enough slack
is left in cables to allow for
movement. When the slot in
each pole cannot be used,
use the supplied Cable Clips
to secure the display cables.
Step 6. Adjust the VESA Ball Mount
Step 7. Cable Management
Step 4. Attach your Display to the Quickshift Donut
TIGHTEN
2mm
Allen Key
Hook the top of the VESA plate onto the
Quickshift Mount.
Insert the Security Screw, and tighten
using the 2mm Allen Key.
CLICK
Gently push the bottom of the Display
into the Mount until you hear a ‘CLICK’.
Back of
Display
VESA plate
Installation Complete
Slide the Quickshift Donut to
desired position.
Close the lever to lock the
Quickshift Donut in place.
Step 5. Adjust the height of the Quickshift Donut
Open the lever to loosen the
Quickshift Donut.
If necessary, adjust the tension
between the Donut and the
Pole using the 5mm Allen key
supplied.
Tightening
Tool
Loosen
(-Kg)
Tighten
(+Kg)
Tension
Plate
WARNING:
Be careful not to overtighten
LOOSEN
TIGHTEN
OPEN
CLOSE
Cable
Clips
Position your Display to the desired viewing angle, using
the 40° angular movement allowed by the VESA Ball Mount.
If the display does not hold its position, or is too resistant,
adjust the Tension Plate (see diagram below).
To make any adjustments, use the Tightening Tool supplied.