Component Checklist
Hardware
Check you have received all parts against this component checklist prior to installation.
Cable
Ball (x4)
M8x50mm
Screw (x1)
Cable
Clip (x3)
2mm Allen
Key (x1)
5mm Allen
Key (x1)
Mounting Screws
M4x10mm (x8)
M4x12mm (x8)
M4x16mm (x8)
TOOLS REQUIRED:
UÊ
Phillips Head Screw Driver
Base
visidec
Upright Pole
Cable Slot
USER
BACK
TIGHTEN
FIRMLY
VESA Plate (x2)
Step 1. Attach Upright Pole to Base
Upright Pole
M8x50mm Screw
5mm Allen Key
Security
Screw (x2)
Quickshift
Donuts (x2)
TIGHTEN
LOOSEN
If the Quickshift Donut requires further
tightening use the supplied 5mm Allen key.
Step 2. Attach Quickshift Donuts to the Visidec Pole
(Ensure the cable slot faces towards the rear)
(Visidec 42mm pole shown)
Slot
Groove
Insert
Close the lever to lock the Quickshift
Donut in place.
Slide the Quickshift Donut onto the Pole.
IMPORTANT INFORMATION
! Each Quickshift Donut supports Flat Panel Displays from 12” (30cm) to 24” (61cm) and supports a maximum weight of 12kg (26½lbs).
! This product suits VESA compliant displays with 75mm x 75mm (3” x 3”) and 100mm x 100mm (4” x 4”) mounting hole patterns.
! The manufacturer does not accept responsibility for incorrect installation.
CLOSE
Tightening Tool
Installation Instructions
Freestanding | Double Vertical
Attach the Upright Pole to the Base as shown
below. Ensure the Cable Slot faces towards the rear.
VFS-DV
Step 3. Attach the VESA plate to your Display
(Repeat Steps 3 to 6 for each Display)
Top of
Display
There are two mounting hole configurations:
UÊÇxÊÝÊÇx
UÊ£ääÊÝÊ£ää
Choose appropriate Mounting Screws
from the Hardware supplied to suit
your Display.
Mounting Screws (x4)
VESA Plate
Back of Display
75mm
(3”)
100mm
(4”)
75mm
(3”)
100mm
(4”)