Step 2. Mount Pole Assembly (cont.)
Step 3. Mount Arm Assembly
2.4
Remove the M8 x 16mm Socket Head Countersunk
Screws to release the Desk Clamp Bracket.
2.3
The Desk Clamp bracket can be repositioned to suit different mounting
surface thicknesses. The maximum mounting surface thicknesses supported
are listed below from the Top to Middle and Bottom Screw Holes.
T
T
M
M
B
B
M8 x 16mm Socket
Head Countersunk
Screw
5mm Allen Key
Desk Clamp Bracket
Pressure Plate
Table Top
M8 x 16mm Socket
Head Countersunk
Screw
M10 Desk Clamp Screw
5mm Allen Key
5mm Allen Key
5mm Allen Key
Arm Assembly
Pole Top Cap
2.5
Place in desired
location.
If you need to reposition the desk clamp bracket or you have no
access to the rear of your table continue to
Step 2.4
.
If you DO NOT need to reposition the desk clamp bracket and
you have access to the rear of your table skip to
Step 2.7
.
2.6
Reattach Desk
Clamp Bracket.
2.7
After positioning
your Pole Assembly,
screw Pressure Plate in
and Tighten Firmly.
3.1
Unlock Handgrip
and raise so that
Handgrip Tab
protrudes.
3.2
Slip the Arm
Assembly over the
Handgrip Tab and then
onto the Pole.
3.3
Slide the Arm
Assembly and Handgrip
down the pole before
locking the handgrip at
the desired height.
3.4
Insert Pole Top
Cap into Pole. This is
also where the Allen
Key is stored.
Desk Clamp Bracket
Handgrip Tab
Top
0 - 32mm (default)
Middle
7 - 47mm
Bottom
22 - 62mm
Top
29 - 69mm
Middle
43 - 84mm
Bottom
59 - 99mm
