Installation Instructions
VF-AT
Component Checklist
Focus | Articulated Arm
M4x10/12/16mm (x4)
Phillips Head Mounting Screws
Primary Arm
Cable Cover
Cable Stops
(x2)
Pole Top Cap
Cable Clip
Secondary Arm
Cable Cover
M8x30mm
Screw
Bolt Through
Base
Steel Washer
Arm Assembly
Pole Assembly
Desk Clamp Assembly
5mm Allen Key
HARDWARE
Display Mounting
Screws
! IMPORTANT - Install Visidec Focus Articulated Arm as per installation instruction.
! This product supports a maximum load of 8kg (17.6lbs).
! The manufacturer accepts no responsibility for incorrect installation.
IMPORTANT INFORMATION:
Step 1. Check Components
Check what you have received against the component checklist and hardware above.
Step 2. Mount Pole Assembly
Option 1
: Bolt Through
Option 2
: Mount using Desk Clamp
Pole Assembly
Pressure Plate
2.1
Remove both the Pressure
plate and M10 Desk Clamp
Screw.
2.2
Fasten the Desk Clamp to the Bolt
Through Base & Pole Assembly using the
M8 x 30mm Screw and
Tighten Firmly.
M10 Desk Clamp
Screw
M8 x 30mm Screw
Bolt Through Base
Pole Assembly
Slot
Slot Tab
Bolt Through Base
Steel Washer
M8x60mm Screw
5mm Allen Key
It is recommended that the Pole Assembly be
mounted towards the rear edge of the work surface.
Note:
Ensure that the Slot Tab in the Bolt
Through Base fits snugly into the Slot on the
Pole Assembly.
The Visidec logo on the Bolt Through Base
must face the
front
of this assembly.
5mm Allen Key
5mm Allen Key
M8x60mm
Screw
