Operating instructions, Quick installation
4
Views in Operating mode
As WST 3 is in Operating mode the views Weight value and Profibus status are
always available. The remaining views can be set On or Off by parameters under
'Main menu General'.
Function keys
and
are used for selection among the available views and
by swiftly pressing
WST 3 can always be switched to the Weight value view
.
From any view, WST 3 switches to Quick set-up mode as the function key
is pressed for 2 seconds.
Weight value, normal view.
This view is always available. It is the first view displayed after start-up, reset or
set-up mode.
The upper line displays the actual weight value as net weight (Net) or gross weight.
The lower line displays status for the used relays, R1:/R2: '1' = on or '0' = off,
and an area for the Modbus address or information about the serial communication.
Zero setting.
This view is made available by parameter 'Zero function'. It displays the actual weight
value as net weight (Net) or gross weight.
As gross weight is displayed it can be set to zero by the ENTER-key
.
By zero setting of the gross weight, the actual tare value is also set to zero.
Start up/Reset
L1 99999.9 kg
Zero
5.430 V 001
L2 0.0 kg
0.18200mV/V
S/N: XX-XXXX
Progr. XXXXXXXX
Weight value
Always On
Zero setting
Set On/Off in Zero function
Analogue output signal
Set On/Off in More views
Level settings
Input signal
S/N:, Progr.
Net 123.4 kg
R1:1 R2:1 001
Net 123.4 kg
Net 123.4 kg
R1:1 R2:1 001
Profibus-DP 010
Online
Profibus status
Always On
Set On/Off in More views
Set On/Off in More views
Set On/Off in More views
Figure 3. WST 3 in Operating mode can always display Weight value and Profibus status.
Depending on the setting, alternative views can also be displayed.
