VirtuFit Water Resistance Row 900
7
EN
8
STEP 4
Attach the Rail (3) to the Main frame (2) with one Bolt (M6*15) (28) and one Barrel nut (M10) (28). Lock
the Rail (3) in unfold position with the Fixing lever (46) and one Washer (
Ø10
) (76)
.
NOTE:
After tightening the Fixing lever (46) the rear stabilizer of the Base frame (1) might be raised
off the floor slightly, this is normal, it will rest on the floor once you are seated.
STEP 5
Install batteries into the Meter (52). Attach the Meter post (6) to Main frame (2) with one Bolt
(M8*135) (64), one washer (Ø8) (78), one lock washer (Ø8) (81), and Acorn nut (M8) (83).
STEP 6
Clip the Grommet (55) on to both sensor wire (54), then press the Grommet (55) into the Left cover
(50). Connect the Sensor wire (54) to the Connection wire of the meter (52). Push the excess wires
back into the Left cover (50).
I. Attach the Rail (3) to the Main frame (2) with one Bolt (M6*15)(28) and one Barrel nut (M10)(28).
Loch the Rail (3) in unfold position with the Fixing lever (46) and one Washer the Rail (3) in unfold
position with Fixing lever (46) and one Washer (Ø10)(76).
NOTE:
After tightening the Fixing lever (46) the rear stabilizer of the Base frame (1) might be raised
off the floor slightly, this is normal, it will rest on the floor once you are seated.
II. Install batteries into the Meter (52). Attach the Meter post (6) to Main frame (2) with one Bolt
(M8*135) (64), one washer (Ø8) (78), one lock washer (Ø8) (81), and Acorn nut (M8) (83).
III. Clip the Grommet (55) on to both sensor wire (54), then press the Grommet (55) into the Left
cover (50). Connect the Sensor wire (54) to the Connection wire of the meter (52). Push the excess
wires back into the Left cover (50).
STEP 2
ASSEMBLY INSTRUCTIONS
