VirtuFit Run Fit Foldable Treadmill
8
EN
STEP 3
�
�
������
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
������
�
�
�
�
�
�
��
�
• When assembly the hand bar, please attention the hand pulse plate need be upward.
• Put the left hand bar(6) through the wave washer (47), and connect the hand pulse wire(A) and (B),
then install the hand bar on the upright as the left picture.
• Then Use 6# Allen wrench (12), bolt(57),Isolation nylon pad(34), Fixed plated (37) lock the left hand
bar(6) on the upright. Then insert the Hand bar plug(52) into the hand bar(6).
• Right side same as left side. As the left picture.
• After using for a time, if the hand bar is loose, put out the Hand bar plug(52) use 6#Allen wrench (12)
to lock again.
NOTE!
The wiring must be connected properly, not cocked, but plugged in place to avoid bad
communication signals. Hand pulse wire(A) and (B) need to be put into the handrail tube as the left
picture A-A, be careful not to press the wire when locking the armrest.
ASSEMBLY INSTRUCTIONS
